Quick answer

  • No. Most heated mattress pads are rated between about 50 and 200 watts, which is a small fraction of a 1,500-watt space heater.
  • A 100-watt pad left on high for a full 8-hour night uses about 0.8 kWh. At 17 cents per kWh, that comes to roughly 14 cents.
  • Real use usually costs less, because the thermostat cycles the heat off and the low settings draw far less than the rated wattage.
  • The bigger savings come from turning your home’s thermostat down at night. A warm bed makes a cooler bedroom easy to live with.

No, a heated mattress pad does not use a lot of electricity. Most draw somewhere between 50 and 200 watts at their highest setting, which is about the same as a couple of old incandescent bulbs and a small fraction of what a plug-in space heater pulls.

For most households, that works out to a dollar or a few dollars a month during the cold season. If you want your own number, the math takes about a minute, and it is laid out below.

Updated November 20, 2026.

How many watts does a heated mattress pad use?

Most heated mattress pads are rated between about 50 and 200 watts, with twin pads at the low end and dual-control queen and king pads at the high end. The exact number is printed on the controller or on the sewn-in tag, usually near the UL or ETL safety listing.

That rated wattage is the most the pad can draw, and it only draws it while the heating wires are on. Modern pads have a thermostat in the controller that switches the heat on and off to hold your chosen setting, so a pad on a middle setting spends a good part of the night drawing nothing.

Dual-zone pads list the total for both sides. If you share the bed and your partner leaves their side off, you pay for half.

How much does it cost to run one all night?

Running a heated mattress pad all night costs a few cents in most homes, and even a worst case lands around a quarter. The formula is simple: watts times hours, divided by 1,000, gives you kilowatt-hours (kWh), and kWh times your rate gives you the cost.

Your rate is on your electric bill, listed in cents per kWh. US residential rates commonly fall in the mid-to-high teens, so the examples below use 17 cents.

  • A 100-watt pad on high for 8 hours uses 0.8 kWh. That is about 14 cents a night, or about $4 over 30 nights.
  • A larger 180-watt pad on high for 8 hours uses 1.44 kWh. That is about 24 cents a night, or about $7 over 30 nights.
  • Preheating on high for 30 minutes and then sleeping on low uses roughly 0.3 kWh. That is about 5 cents a night, or around $1.50 a month.

If your rate is higher, as it is in much of New England and California, scale the numbers up. At 30 cents per kWh, the worst-case 100-watt night still comes to about 24 cents.

For a sense of scale, a pad on a low setting draws power in the same range as a slow cooker left on warm overnight. Neither one will move your bill much.

How does it compare to a space heater or the furnace?

A heated mattress pad uses a small fraction of the power of a space heater, and it heats the only thing you care about at 2 a.m., which is you. A standard plug-in space heater runs at up to 1,500 watts, so even if it cycles off half the night, it can use around 6 kWh, or roughly a dollar a night at 17 cents.

That gap comes from what each one heats. The space heater warms the air, walls, and furniture in the room, while the pad warms a mattress top and a sheet. If you still want room heat, our guide to sizing a space heater for a bedroom by square foot covers when a small unit makes sense.

The bigger comparison is your furnace or heat pump. The U.S. Department of Energy says turning your thermostat back 7 to 10 degrees Fahrenheit for 8 hours a day can save up to 10 percent a year on heating and cooling.

So the pad costs a little, and the cooler house it lets you sleep in can save more than that. The payoff is largest in homes with electric baseboard or other resistance heat.

How can you cut the cost even further?

The cheapest way to run a heated mattress pad is to preheat the bed, then turn it down or off when you get in. The sheets and the top of the mattress hold warmth for a while, and your own body heat does the rest under a decent comforter.

  • Use the preheat or timer function if your controller has one, so the pad shuts itself off after you fall asleep.
  • Sleep on the lowest setting that feels comfortable. On many pads, the bottom settings keep the wires off most of the time.
  • Keep a warm comforter on top so the heat stays in the bed instead of drifting into the room.
  • On dual-zone pads, run only the side that someone is sleeping on.
  • Close the bedroom door and drop the thermostat a few degrees overnight, since that is where the bill goes down.

One thing that does not help is a thick foam topper laid over the heated pad. It slows the heat on its way to you, so check your manual before stacking layers, because many say the pad belongs directly under the fitted sheet.

Is it safe to leave a heated mattress pad on all night?

A modern heated mattress pad with an auto shutoff and a recognized safety listing is designed to run overnight, as long as it is in good shape and set up correctly. Many controllers turn the pad off on their own after about 10 hours, which also caps your worst-case electricity use.

  • Look for a UL or ETL mark on the controller or tag.
  • Do not tuck the pad in tightly or let it bunch up, since folded wires can overheat.
  • Replace a pad with scorched spots, a frayed cord, or a controller that gets hot to the touch.
  • Do not use one in a crib, or for anyone who cannot feel heat well or cannot turn the controller off on their own.

Any heating appliance that smells hot deserves attention, and many of the causes overlap with the ones in our post on why a space heater smells like burning. If the smell is musty and comes from the whole house when the furnace starts, that is a different problem, and this guide to a musty house when the heat is on walks through it.

Frequently asked questions

How many watts does a queen heated mattress pad use?

Queen pads are usually dual-zone and often list somewhere between about 100 and 200 watts total with both sides on high. Check the controller or the sewn-in tag for the exact rating. Real use is lower, because the thermostat cycles the heat off once the bed is warm.

Is a heated mattress pad cheaper to run than an electric blanket?

They draw power in a similar range, so the running cost is close. A pad sits under you and warms the mattress surface, while a blanket sits on top and loses some heat to the room. Pick the one you find more comfortable, since neither will change your bill much.

Does a heated mattress pad use more electricity on high?

Yes. On high, the thermostat keeps the heating wires on for more of each hour, so the pad runs closer to its rated wattage. On low, the wires spend much of the night switched off.

Can you put a mattress topper over a heated mattress pad?

Check your manual first, because many tell you to place the pad directly under the fitted sheet. A thick foam topper on top slows the heat getting to you and can trap it. A foam topper under the heated pad is the usual setup.

If your question is whether a heated mattress pad will wreck your winter electric bill, it will not. Expect a few cents a night, and less if you preheat and sleep on low.

Heated pads go on sale this week along with most other bedding, and the Berry Finds deals page tracks current markdowns. When you compare models, look for an auto shutoff and a safety listing first, and get dual controls if you share the bed and run warmer or cooler than your partner.